GL.iNet Router SDK/multiwan — English @ Weblate for GL.iNet: Multi-WAN

Zen

	Key	English	Actions
	menu_multiwan	Multi-WAN
	multiwan.tips	The router supports connections to multiple network interfaces at the same time. You can configure how these multiple networks should be used.
	multiwan.failover_desc	Failover: If the current, active link fails, the router will automatically switch to another network interface.
	multiwan.balancing_desc	Load Balance: Uses multiple network interfaces at the same time to increase the total bandwidth of the router. Note that connections to the same application or site will usually only use one interface.
	multiwan.mode_label	Mode
	multiwan.mode_failover_tips	The router automatically selects the next available interface with the highest priority.
	multiwan.mode_balancing_tips	The system will assign interfaces to new connections based on the load ratio.
	multiwan.mode_balancing_note	Note: Active connections or traffic are not redirected to match the load ratio.
	multiwan.failover_label	Failover
	multiwan.balancing_label	Load Balance
	multiwan.track_title	Interface Status Track
	multiwan.physical_state_monitor	Internet always available when the interface is connected
	multiwan.priority_title	Interface Priority
	multiwan.ratio_title	Load Ratio
	multiwan.track_desc	The router tracks the status of the connection to the destination IP to establish whether the interface is available.
	multiwan.track_enable_tips	If tracking is disabled, the device will assume that the interface is connected to the Internet when the interface is connected (e.g. if a cable is plugged in and an IP address is acquired).

	Key	English	Actions
	menu_multiwan	Multi-WAN
	multiwan.available_condition_label	Change to Available Condition
	multiwan.balancing_desc	Load Balance: Uses multiple network interfaces at the same time to increase the total bandwidth of the router. Note that connections to the same application or site will usually only use one interface.
	multiwan.balancing_label	Load Balance
	multiwan.balancing_warning_tips	At least two interfaces with non-zero load ratios must be configured for the balanced load to work properly. If there is no connectable Internet interface with a non-zero load ratio, the device will not be able to connect to the Internet.
	multiwan.both_label	Both
	multiwan.det_mode_label	Detection Mode
	multiwan.det_mode_tips	检测模式的提示
	multiwan.enable_check_label	Enable Interface Status Track
	multiwan.failover_desc	Failover: If the current, active link fails, the router will automatically switch to another network interface.
	multiwan.failover_label	Failover
	multiwan.fault_condition_label	Change to Failure Condition
	multiwan.fault_count	Fail $$$$ times
	multiwan.flush_track_label	Forced Refresh Streams
	multiwan.flush_track_tips	If this option is enabled and the network interface changes, the router will refresh all existing data streams to ensure they are using the highest priority interface. This avoids unnecessary traffic loss, but can lead to an increase in network volatility (for example, some VPNs may not reconnect immediately).

Loading…

None

String updated in the repository

English

English 9 characters edited Current translation Translated

a year ago

Browse all string changes

Things to check

Multiple failing checks

Following checks are failing:
Unchanged translation: Dutch, Italian, Polish

Reset

Glossary

English	English
No related strings found in the glossary.

String information

Key

menu_multiwan

String age

a year ago

Last updated

a year ago

Source string age

a year ago

Translation file

multiwan/en.json, string 1